Welcome to the Culver Aircraft Forum
Culver Cadet Section => Culver General Discussion => : Dan Rhinehart June 26, 2012, 05:24:41 PM
-
Hi all,
Does anyone out there have a picture or general measurements for the wood seat back? (not the seat cushions)
Is this just a piece of plywood? How thick? How tall? What if any braces etc...???
-
Dan.
I have a seat back without the cover. Will get the dimensions and post here later today
Frame is 341/2" long by 173/4" high with a center brace in it. Frame is 7/8" deep by 5/8" wide stock with 16 1/2" long center brace. Bottom of frame is cut at 45 degree angle at the corners. 1/8" Luna for the skin. All corners are blocked with 45 degree blocks. Three hinges at bottom.