Welcome to the Culver Aircraft Forum
Culver Cadet Section => Culver General Discussion => : craighewitt July 24, 2013, 06:49:33 PM
-
I finally found some time to work on my Culver.The interior cabin area is now ready to apply some kind of finish.Can i put new varnish over the old?What have people been using to clean the old varnish? Thanks Craig
-
Craig,
With mine I used acetone to knock the varnish down with a scraper. If the build up is not too much, you can spray another light coat over the old one but it adds weight. With the bottom of fuselage open, turn it on it's side and have at it.
-
Thanks Woody,will modern varnish be ok over what was used then? Craig
-
I would think so ~~ it does not touch fabric or metal so there is no adhesion problems that I know of. It worked on mine which is all I know. W
-
I ended up lightly sanding it cleaning it with a rag and putting a light coat of polyurathane and it seems fine with negligable weight gain.I'm amazed that the engine is mounted with such light bolts! Craig
-
As for me I have used Stitts epoxy varnish and it goes over anything.