Culver Cadet Section > Maintenance and Repair

LCA exhaust


Keith U.:
To make the exhaust for my LCA,  I tried some off the shelf stacks from an Aeronca Chief, but did not like the exit point.  Rather than modify it, I took Service Memo #7 off from Bill's site, took some pvc, made a mock up and sent it to Dawley Aviation, Burlington, WI.  They tack welded a pair out of stainless steel, then sent to me to test fit.  All was good so they finished welded it.  Its as close to original as I could get.  The carb heat shroud is a modified Cessna part, the cabin heat is the same, but I am not real confident the cabin heat will work with out forced air.  Final length will be trimmed after cowling is fit.  Its been exhausting.


[0] Message Index

Go to full version