Author Topic: Franklin engines  (Read 8983 times)

Tim Lunceford

  • *
  • Posts: 44
    • View Profile
  • N Number: 18064 41726 41722
Franklin engines
« on: February 23, 2012, 12:00:21 PM »
Both my Cadets have the Franklin 90hp in them.  I have a brand new in the crate Franklin 0-235 of 130 hp.  It appears that it would bolt in with out much modification.  Has anyone done this?   Any thoughts if the airframe can handle the extra power?  I believe that there would be no weight increase over the stock 90hp.     Tim

Bill Poynter

  • Administrator
  • Full Member
  • *****
  • Posts: 231
    • View Profile
  • N Number: N41637
Re: Franklin engines
« Reply #1 on: February 23, 2012, 01:07:52 PM »
I believe the Franklin O235 was designed to bolt directly onto a Continental O200 mount. 

As for the horsepower increase, the PQ-8A used the Lycoming O290 of 125 HP.  I don't know if the fuselage was beefed up, but they sure put an ugly enlarged rudder on it. 

If you are willing to go experimental, it might be economically feasible, but I think trying to get the FAA to bless it for a standard C of A would be very difficult (expensive).   

Dan C

  • *
  • Posts: 11
    • View Profile
Re: Franklin engines
« Reply #2 on: February 23, 2012, 05:52:23 PM »
The Franklin 4A-235 series came either with a bed mount, like most Franklins, or could be supplied with the rear mount to replace the Continental O-200. Aircooled Motors was far more resourceful and accommodating to customer demands than competitors. A great product for it's time. So was Studebaker....I have both.