« previous next »
Pages: [1]   Go Down

Author Topic: Back again!  (Read 8976 times)

Woody

  • Jr. Member
  • **
  • Posts: 93
    • View Profile
Back again!
« on: October 26, 2016, 03:27:33 PM »
Hello everyone,
  I'm back working on my Culver and I really need a set of plans or at least the tail section of the fuselage!  Any help would sure be appreciated!  I'm willing to pay if cost is a problem.
My wings are ready for fabric and a little work on the tail section of the fuselage will complete the fuselage. Then I am ready to start putting it back together.
Logged

Tim Lunceford

  • *
  • Posts: 44
    • View Profile
  • N Number: 18064 41726 41722
Re: Back again!
« Reply #1 on: December 20, 2016, 12:08:41 PM »
Woody,  I have been very busy working on the Heath Cannon project and have not check the Culver site, just saw you post.   Did you get any help?  I do not have plans but have lots information on the Cadet.  May be I have something that can help.   Tim







Logged

Woody

  • Jr. Member
  • **
  • Posts: 93
    • View Profile
Re: Back again!
« Reply #2 on: December 22, 2016, 08:43:38 PM »
 Hi Tim,
 Thanks for answering!  No help but I have downloaded pictures and I also have a fuselage
 that I'm using as patterns.  It is winter and I'm getting slower!  I'm rebuilding the tail section now.  Wings are done without fabric and I have a new Franklin 90 HP engine to mount. I'll post as I progress and run into trouble.  Plans would be worth a lot!  Woody
Logged
Pages: [1]   Go Up
« previous next »