Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Gregory

Pages: [1]
1
Culver General Discussion / Re: New Member
« on: December 29, 2012, 11:26:36 PM »
Hi Phil,

I am very close to Toronto, but I always liked watching Edmonton Oilers with Gretzky.
So you have the only one Culver Cadet in Canada;  so nice.
Do you fly the Cadet or is it a project?
I would like to get one, so I may need some advice.

What is you e-mail and Tel number?

Gregory
905-569-5542
g.sachs@sympatico.ca

2
Culver General Discussion / Re: New wings for the Culver Cadet
« on: December 28, 2012, 08:09:11 PM »
Hi Neal,

I am a new Forum member, very much interested in Culver Cadet.   Do you still offer the plans for the STF?
How I can contact you?
My e-mail address is:  g.sachs@sympatico.ca.

Regards,
Gregory

3
Culver General Discussion / New Member
« on: December 28, 2012, 08:01:29 PM »
Hi Folks,

I have been interested in small planes for about 30 years, I was an EAA member in the 1980s, and RAA (Canada) since then.  I am also a glider pilot.  I like Culver Cadet, and would get one or build one, but I need some advice from the Forum members. 
 So far I see 3 models:  Culver Cadet LCA (Continental) and LFA (Franklin), as well as Neal La France's STF (Experimental).  Question:  are any Culver Cadets available for sale now?  I would be interested in rebuilding one.  Or is it better to go with the Experimental one?
Also, I noticed that the STF is missing the Slots in front of ailerons;  the LCA and LFA have the slots.  The slots are there to improve flight control at low air speeds, right?
Are the plans for STF still available?
I admired the twin Culver Cadets flying on the YouTube.

Regards,
Gregory

Pages: [1]